1. |
Place roof panels upside down on a soft surface to prevent scratching the glass.
|
2.
|
Remove plastic tongue covers (1 phillip screw each) and plastic latch covers phillip screws each.
|
3. |
Loosen (do not remove) all 7/16" nuts. There are a total of 7 nuts per top, 2 per tongue and three per latch.
|
4. |
Distinguish a mark using tape and a pencil on center of car by measuring from the left and right front locating pins holes to the center of T-Sar above the windshield.
|
5. |
Open the car doors and place T-Tops on car so tongues go into T-Sar, (see view A above) and front locating pin on latch assembly goes into hole.
|
6. |
With T-Tops on car, close latches on both tops. watching for rear locating pin to engage in switch plate.
|
7. |
Use center mark as a reference point to align tops. Move the tops side to side until you achieve a parallel position down the center or the T-Tops and across the back.
|
8. |
With T-Tops parallel tighten latch nuts.
|
9. |
Go inside car and tighten tongue nuts. NOTE: Adding shims raises top and deleting shims lowers top.
|
10. |
If T-Tops appear unlevel return to the inside of the car and add or delete shims as necessary.
|
11. |
If necessary, loosen latch and readjust tops to compensate for alignment.
|
12. |
Replace all plastic covers to the T-Top panels and return panels to car. |